ASTM A420 WPL6 Charpy Impact Test at -45°C: Buyer Guide

What the Standard Actually Requires

For each heat of WPL6, ASTM A420 requires Charpy V-notch impact testing on a set of 3 specimens at -50 °F (-45 °C):

Specifically the test reports:

• Absorbed energy (ft·lbf or J)
• Lateral expansion (mils or mm)
• Percentage of shear fracture surface

If the average of the 3 specimens fails, retest is allowed under controlled conditions per the standard. If even one single specimen falls below the lower bound, the heat is rejected.

What to Check on the MTC

For WPL6 fittings the mill test certificate must include all of the WPB chemistry items plus the impact-test block:

• Test temperature explicitly stated (-50 °F or -45 °C)
• All 3 specimen energy values + average
• Lateral expansion values
• Fracture appearance (% shear)
• Notch type: Type A standard 10 × 10 × 55 mm V-notch

If the MTC shows "tested at -29 °C" (the typical WPL3 temperature) and the certificate is stamped "WPL6", reject — the test temperature must match the grade.

Common Issues at Inspection

1. Sub-size specimens: 7.5 × 10 × 55 mm or smaller is permitted only when the wall thickness physically does not allow a full 10 × 10 specimen — the energy values must be adjusted per the standard. Many MTCs forget the adjustment.

1. "At room temperature" Charpy: worthless for WPL6. The whole point of the grade is the low-temp performance — the test temperature must be -50 °F.

1. Single-specimen test: the standard requires 3 specimens (a "set"). One value alone is non-conforming.

1. Mother-material MTC missing the impact block: for processed fittings (elbows, tees, reducers) the mother pipe must also have been impact-tested. Cross-check.

Practical Buying Checklist

• [ ] Confirm design minimum temperature is between -45 °C and 0 °C (otherwise WPL6 may not be suitable)
• [ ] PO calls out "ASTM A420 WPL6, normalised, Charpy V-notch impact test at -50 °F (-45 °C), average of 3 specimens"
• [ ] PO requires impact test on both the finished fitting and the mother material
• [ ] MTC type is EN 10204 3.1 minimum; specify 3.2 (independent inspector) for PED Cat IV / sour service / subsea
• [ ] Material marking includes "WPL6" on the body, not just on a sticker

This article references the public ASTM A420 standard. The latest published edition takes precedence for any project specification.

Related Products

For physical supply of the specs discussed above, refer to the relevant Hebei Haihao product categories:

• seamless butt-welding pipe fittings
• forged flanges and nonstandard forgings

Or browse the full product catalogue and filter by ASTM / ASME / EN / GB standards, material grades, and size ranges.

Further Reading

• ASTM A234 WPB Heat Treatment & Chemistry guide
• EN 10204 3.1 vs 3.2 mill test certificates

Next Steps

• This article is a procurement reference; all standard numbers, chemistry limits, and process parameters defer to the latest published edition
• For project RFQs, submit your specs via the inquiry form; we respond within 4 business hours
• Factory certifications and inspection capability are listed on the certificates page